Craftsman 3One 917.255470 Owner's Manual page 24

TO REPLACE FUSE
Replace with 30 amp automotive-type plugqn fuse. The
fuse holder is located in the engine compartment, directly
in front of the dash_
TO REPLACE HEADLIGHT BULB
- Raise hood.
° Pull bulb holder out of the hole in the backside of the
gdll_
o Replace bulb in holder.and push bulb holder securely
back into the hole in the backside of the grill.
o Close hoed.
INTERLOCKS AND RELAYS
Loose or damaged wiring may ,cause your tractor to run
poorly, stop running or prevent it from starting°
o Check wiring., See the electrical wtdng diagram In the
Repair Parts section of this manual..
TO REMOVE HOOD AND GRILL (See Fig, 30)
_' Raise hood,
, Unsnap headlight wire connector_
= Stand in front of tractor. Grasp hood at sides, tilt
forward and liftoff of tractor,
o To reinstall, slide hood pivot brackets into slots in
frame.
• Reconnect headlight wire connector and close hood.
HEADLIGHT
WIRE
CONNECTOR
ENGtINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 31)
The throttle control has been preset at the factory and
adjustment should not be necessary,,Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceedas follows:
o With engine not running move throttle control ]ever
from "SLOW" to "CHOKE"position.. Slowly move lever
from "CHOKE" to "FAST" position.
GOVERNOR GOVERNOR
CONTROL LEVER CONTROL PLATE
HOLES "A"
CLAMP THROTTLE
SCREW CABLE
FIG. 31
FIG. 3O
24