Craftsman 3One 917.255470 Owner's Manual page 20

o
o
u
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake pedal fully and set parking brake.
Place gearshift lever in "NEUTRAL" position,
Place attachment clutch in "DISENGAGED" position.
Turn ignition key "OFF" and remove key°
Make sure the blades and all moving parts have completely stopped°
Disconnect sparkplug wire from spark plug and place wire where it cannot come in contact with
plug.
...................................... ,_ , ,,,,,,, ,,,, ,,,,,,,, i iii,
TRACTOR
TO REMOVE MOWER (See Fig. 20)
Mower will be easierto remove from therightside of tractor,
• Place attachment clutch in ';DISENGAGED" position,
= Move attachment lift leverforward to iowermower to its
lowestposition,,
. Roll beit off engine pulley.
= Disconnect clutch red from clutch lever by removing
retainer spring.
, Disconnect anti-sway bar from chassis bracket by
removing retainer spring..
, Disconnect suspension arms from rear deck brackets
by removing retainer springs..
o Disconnect front links from deck by removing retainer
spr]ngs,
o Raise lift lever to raise suspension arms. Slide mower
out from under tractor,,
IMPORTANT: IF AN ATTADHM ENT OTHER THAN THE
MOWER IS TO BE MOUNTED TO THE TRACTOR, THE
R.H. AND L.,H. SUSPENSION ARMS MUST BE REMOVED
FROM TRACTOR
TO INSTALL MOWER (See Fig. 20)
= Raise attachment lift lever to its highest position,
o Slide mower undertractorwith discharge guardto right
side of tractor,
o Lewer lift lever to its lowest position,,
,, Install mower in reverse order of removal instructions°
CLUTCH ROD
CLUTCH LEVER
RETAINER
SUSPENSION
ARMS
ENGINE
PULLEY
RETAINER
(BOTH
S_DES)
RETAINER
SPRING
ANTI-SWAY
BAR
RETAINER
SPRINGS
(BOTH SIDES)
FIG. 20
2O