Table of Contents
Advertisement
I U LsLr-/-_l_l D/_I
I El"tT /-_l_lU I F-I-tMII_I/AL,_
Corrosion and dirt on the battery and ter-
minals can cause the battery to =leak"
power.
• Remove terminal guard.
• Disconnect BLACK battery cable first
then RED battery cable and remove
battery from tractor.
• Rinse the battery with plain water and
dry.
• Clean terminals and battery cable ends
with wire brush until bright.
• Coat terminals with grease or petroleum
jelly.
• Reinstall battery (See =REPLACING
BATTERY" in the SERVICE AND
ADJUSTMENTS
section of this manu-
al).
V-BELTS
Check V-belts for deterioration and wear
after 100 hours of operation and replace if
necessary_-Thebelts-are
not adjustable.
Replace belts if they begin to slip from
wear.
TRANSAXLE
COOLING
The transmission fan and cooling fins
should be kept clean to assure proper
cooling.
Do not attempt to clean fan or transmis-
sion while engine is running or while the
transmission Is hot.
• Inspect cooling fan to be sure f._n
blades are intact and clean.
• Inspect cooling fins for dirt, grass clip-
pings and other materials. To prevent
damage to seals, do not use com-
pressed air or high pressure sprayer to
clean cooling fins.
TR._NSAXLE
PUMP FLUID
The transaxle was sealed at the factory
and fluid maintenance is not required for
the life of the transaxle. Should the
transaxle ever leak or require servicing,
contact your nearest authorized service
center/department.
ENGINE
....
LUBRICATION
Only use high quality dete?gent oil rated
with API service classification SF, SG, or
SH.
Select the oil's SAE viscosity grade
according to your expected operating tem-
perature.
<
I
),
mira
_I =
_
V
_
_
_
_Ir
IO°
1_
•rem, e_'r_e RANGe _rncPA_o.a=o_ ._xr o..ow_e
_nange
me Oll alter every bo hours ol
operation or at least once a year ifthe
tractor is not used for 50 hours in one
year.
Check the crankcase oil level before start-
ing the engine and after each eight (8)
hours of operation. Tighten oil fill cap/dip
stick securely each time you check the oil
level.
TO CHANGE
ENGINE OIL
Determine temperature range expected
before oil change. All oil must meet API
service classification SF, SG, or SH.
• Be sure tractor is on level surface.
• Oil will drain more freelywhen
warm.
• Catch oiHn a suitable container.
• Remove oil f,I cap/dipstick. Be careful
not to allow dirt to enter the engine
when changing oil.
• Remove drain plug.
• After oil has drained completely, replace
oil drain plug and tighten securely.
• Refill engine with oil through oil fill dip-
stick tube. Pour slowly. Do not overfill.
For approximate capacity see =PROD-
UCT SPECIFICATIONS"
on page 5 of
this manual.
• Use gauge on oil fill cap/dipstick for
checking level. Insert dipstick into the
tube and rest the oil fill cap on the tube.
Do not thread the cap onto the tube
when taking reading,
Keep oil at
=FULL" line on dipstick. Tighten cap
onto the tube securely when finished.
CLEAN AIR SCREEN
Air screen must be kept free of dirt and
chaff to prevent engine damage from over-
heating. Clean with a wire brush or com-
pressed air to remove dirt and stubbom
dried gum fibers.
Oil Drain Plug
Oil Fill
Nr Screen
Cap/Dipstick
21
Hide quick links:
Advertisement
Table of Contents
