Attaching The Handle - Craftsman Weedwacker 358.795320 Operator's Manual

legally responsible for installing and tion of the law, Contact your Sears
maintaining the operating condition of Service Center for the correct parts.
these parts. Failure to do so is a viola-
CARTON CONTENTS
Check carton contents against the fol-
lowinglist.
Model 358,795320
• Trimmer
• Shield with wing nut
• Assist Handle with'bolt and wing nut
• Container of Oil
• Spool with 20 ft. of line
Examine parts for damage, Do not use
damaged parts.
NOTE: it you need assistance or find
pads missing or damaged, call
1-800-235-5878.
It is normal for the fuel filter to rattle in
the empty fuel tank,
Finding fuel or oil residue on muffler is
normal due to carburetor adjustments
and testing done by the manufacturer.
ASSEMBLY
WARNING: If receivedassembled,
repeatall stepsto ensureyourunitis
pmpedyassembledand all fasteners
are secure.
Be suretoassemblethe handleto the
unitbeforeyou assemblethe shield.
ATTACHING THE HANDLE
(some units are already assembled)
WARNING: Make sure unit is propedy
assembled and all fasteners are secure.
• Assembiehandletotheunitasshown;
make sure bottom of handle is seated
in the groove in the trigger housing.
NOTE: Wing nut must be assembled
on the right hand side of the unit as
shown in the above illustration.
• Make sure the bolt is seated into the
hex shapped hole in the handle.
• Pivot handle to a comfortable position.
• Tighten handle securely.
ATTACHING SHIELD
WARNING: The shield must be prop-
erly installed.The shield providespartial
protectionfrom the risk of thrown objects
to the operator and othersand is
equipped with a line llm_terwhich cuts
excess lineto the proper length. The line
limtter(on undersideof shield) is sharp
and can cut you. For proper orientation,
see illustrationin Operation section.
• Remove wing nut from shield.
- Insert bracket into slot as shown.
• Pivot shield until bolt passes through
hole in bracket.
• Securely tighten wing nut onto bolt.
_-_ Slot
"_,__ Bracket
Wing
nut