Assembly; Carton Contents; Attaching Shield - Craftsman Weedwacker 358.791980 Operator's Manual

CARTON CONTENTS
Check carton contents against the fol-
lowing list.
Model 358.791980
• Trimmer
• Shield
• Wing Nut (screwed onto shield)
• Container of line
• Container of oil
Examine parts for damage. Do not
use damaged parts.
NOTE: If you need assistance or find
parts missing or damaged, call
1-800-235-5878.
It is normal fur the fuel filter to rattle in
the empty fuel tank.
Finding fuel or oil residue on muffler is
normal due to carburetor adjustments
and testing done by the manufacturer.
ASSEMBLY
_WARNING: IfreceNed as-
sembled, repeat all steps to ensure
your unti is properly assembled and all
fasteners are secure.
ADJUSTING THE HANDLE
the safety label and below the mark or
arrow on the sha_.
f. Loosen wing nut on handle.
2. Rotate the handle on the shaR to an
upright position; retighten wing nut.
A'I-rAC HING SHIELD
_' WARNING: The shield must be
properly installed. The shield provides
par_al protection from the risk of thrown
objects to the operator and others and
is equipped with a line limiter blade
which cuts excess line to the proper
leng_. The line limiter blade (on under-
side of shield) is sharp and can cut you.
For proper orienta_on of shield, see
KNOW YOUR TRIMMER illustration in
OPERATION section.
1. Remove wing nut,Tom shield.
2. Insert bracket into slot as shown.
3. Pivot shield until bolt passes
through hole in bracket.
4. Securely tighten wing nut onto pelt_
Bracket _ng Nut
Shield