Craftsman 315.284610 Operator's Manual page 22

Toadjust(horizontally):
[] Remove t hebladeguardassembly a ndanti-kickback
pawls.
[] Raise thebladeto itsfullheight.
[] Insert t hehexkeythrough theslotonthebackofthe
saw.Twoadjustment screws canbeaccessed t hrough
theslot.
[] Turn theadjustment screwsto reposition t hespreader/
rivingknifeleftor rightas needed to alignthespreader/
rivingknifewiththesawblade.
[] Onceproperly aligned, s ecurely retighten t hescrews.
To adjust (vertically):
[] Push either side of the riving knife to align it top
to bottom with the blade. Check its position after
adjustment to ensure that it is vertically aligned with
the blade.
PUSH STICK STORAGE
See Figure 19.
[] Insert the push stick storage screws from the loose
parts bag into the holes on the side of the saw table.
Use a Phillips head screwdriver to tighten screws
securely.
[] Place the slots in the push stick over the screws and
slide the push stick toward the back of the saw.
PUSH STICKSTORAGE
SCREW(S)
BLADE
HORIZONTAL ADJUSTMENT
1
I
SPREADER/
RiViNG KNIFE
PUSH STICK
Fig. 19
VERTICAL ADJUSTMENT
BLADE
FRAMING
SQUARE
I
SPREADER/
RiViNG KNIFE
Fig. 18
22