Depth Of Cut Adjustments When; Mounted To A Router Table; Variable Speed; 315. 175050 And 315.175060) - Craftsman 315.175040 Owner's Manual

DEPTH OF CUT ADJUSTMENTS WHEN
ROUTER IS MOUNTED TO A ROUTER TABLE
See Figure 7.
The depth of cut is readable from both sides of the depth
indicator ring. The bottom ring is convenient when using
your router mounted upside down to a router table. The
indicator point on the base can also be used when using
your router mounted to a router table.
Set the cutter at zero depth of cut, rotate depth indicator ring
to desired depth of cut on the scale, then tighten locking
knob securely.
VARIABLE SPEED
(MODEL NOS. 315.175050 AND 315.175060)
See Figure 8.
If your router is either one of these two models, it has a
variable speed control selector designed to allow operator
control of speed and torque limits. To increase the speed and
torque of your router, tum the variable speed controlselector
to a higher setting. Turn to a lower setting to decrease speed
and torque.
NOTE: If you do not want to use the variable speed control
selector, turn to the highest possible setting and the feature
will not be active.
PRACTICE BEFORE ACTUAL USE
If your router is Model No. 315.175050 or 315.175060, we
suggest that you practice with the vadable speed feature of
your router before installing a cutter and making cuts in
wood. Check the following before connecting your router
to power supply.
• Make sure power supply is 120 volts, 60 Hz, AC only.
• Make sure the spindle lock is in the unlocked position.
/
• Make sure the _gger is not in the lock-on position.
• Make sure there is not a cutter in the collet.
• Make sure the collet does not extend below the subbase.
• Choose the desired speed from the speed selection
chart. See Figure 8.
• Turn the variable speed control selector to the desired
setting.
• Plug your muter into power supply source. ..
• Grasp your router firmly with both hands and turn on.
MODELNOS.315.175050AND315.175060
CUTTER SIZE'
SPEEDSELECTION CHART
POWER
HANDLE
TO DECREASE
SPEEDANDTORQUE
/
TO INCREASE
SPEEDANDTORQUE
VARIABLESPEED
CONTROLSELECTOR
Fig. 8
Page12