Depth Of Cut Adjustments - Craftsman 315.175040 Owner's Manual

DEPTH OF CUT ADJUSTMENTS
See Figures 4, 5, _nd 6.
We recommend that cuts be made at a depth not exceeding
118 in. and that several passes be made to reach depths of
cut greater than 118 in.
[u uoo ou !
Failure to unplug your router could result in accidental
starting causing serious injury.
• Place your router on a fiat surface, loosen locking
knob, and tum depth adjusting ring until cutter is inside
-- _subbase. See Figure 4.
•Tum depth adjusting ring until tip of cutter touches fiat
surface. Tum the depth indicator ring until the zero lines
up with the indicator point on the base. NOTE: The
depth indicator dng is also a zero reset indicator when
setting cutter at zero depth of cut, then it becomes the
depth adjusting ring. See Figure 5.
• Position your router so that the cutter can extend below
the subbase for desired depth setting. See Figure 6.
• Tum the depth adjusting ring to obtain the desired depth
of cut. The distance the cutter moves can be read on the
depth indicator ring. Each mark on the depth indicator
ring indicates 1116inch change in depth setting. Indicator
point is located on the base.
• Tighten locking knob securely before operating router.
Fig. 4
cUTrER AT ZERO
DEPTHOF CUT
Fig. 5
Pa_e 11