Advertisement
Available languages
Available languages
TO REPLACE
MOWER
BLADE
DRIVE
BELT
The mower blade drive belt may be replaced
without tools.
Park the tractor on level sur-
face.
Engage
parking brake.
BELT REMOVAL
-
1. Remove
mower from tractor
(See "TO
REMOVE
MOWER"
in this section
of
manual).
2. Work belt off both mandrel
pulleys and
idler pulleys.
3. Pull belt away from mower.
BELT INSTALLATION
-
I.
Work belt around both mandrel
pulleys
and idler pulleys
2. Ensure
belt is in all pulley grooves
and
inside all belt guides.
3. Install mower (See "To install Mower" in
this section of this manual).
Idler Pulleys
Pulley
TO CHECK BRAKE
If tractor requires more than five (5) feet to
stop at highest speed in highest gear on a
level, dry concrete or paved surface, then
brake must be serviced.
You may also check brake by:
1. Park tractor on a level, dry concrete or
paved surface, depress clutch!brake
pedal all the way down and engage
parking brake,
2. Place gear shift lever in neutral position.
The rear wheels must lock and skid when
you try to manually push the tractor forward.
If the rear wheels rotate, then the brake
needs to be serviced. Contact a Sears or
other qualified service center.
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface, Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom side
of left footrest.
BELT REMOVAL-
t, Remove mower (See "TO REMOVE
MOWER" in this section of manual).
NOTE: Observe entire motion drive belt
and position of all belt guides and keep-
ers.
2, Remove bett from stationary idler and
clutching idler.
3, Remove belt downward from around
engine pulley.
4. Pull belt slack toward rear of tractor.
Remove belt upwards from transax{e
pulley by deflecting belt keepers,
5. Remove belt from center span keeper
and pull belt away from tractor,
BELT INSTALLATION -
1. Carefully work new belt down between
transaxle belt keepers and onto the
input pulley.
2. Slide belt into the center span keeper.
3. Pul! belt toward front of tractor and roll
around the top groove of engine pulley.
4, Install belt through stationary idler and
clutching idler,
5. Make sure belt is in all pulley grooves
and inside alebelt guides and keepers.
6, Install mower (See "TO INSTALL
MOWER" in this section of manual).
Engine
Pulley-_
Clutching_
Idler
StationaryJ
Center Span
Keeper
;ru_n_x_
23
Advertisement
