Table of Contents
Advertisement
TO DRIVE TRACTOR OFF SKID (See
Operation section for location and
function of controls)
_1, WARNING:
Before starting, read
understand
and follow a
nstructions
in
the Operation section of this manual. Be
sure tractor is in a well-ventilated
area. Be
sure the area in front of tractor is clear of
other people and objects.
1. Be sure all the above assembly
steps
have been completed.
2. Check engine oil level and fill fuel
tank with gasoline.
3. Place freewheel
control in "transmis-
sion engaged"
position.
4. Sit on seat in operating position,
depress brake pedal and set the
parking brake.
5.
Press lift lever plunger and raise
attachment
lift lever to its highest
position.
6. Start the engine. After engine has
started, move throttle control to idle
position.
7. Release parking brake.
8. Slowly move the motion control lever
forward and slowly drive tractor off
skid.
9. Apply brake to stop tractor and set
parking brake.
10.Turn ignition key to "OFF" position.
Continue with the instructions
that follow.
INSTALL
MOWER
AND DRIVE
BELT
Be sure tractor is on level surface and
mower suspension
arms are raised with
attachment
lift control. Engage parking
brake.
1. Cut and remove ties securing anti-
sway bar and belts.
Swing anti-sway
bar to left side of mower deck.
2. Slide mower under tractor with
deflector shield to right side of tractor.
IMPORTANT:
Check belt for proper
routing in all mower pulley grooves.
3. If equipped,
turn height adjustment
knob counterclockwise
until it stops.
4. Lower mower linkage with attachment
lift control.
5. Install belt into electric clutch pulley
groove.
6. Place the suspension
arms on
outward pointing deck pins.
Retain
with double loop retainer spring with
loops up as shown.
7. Install front plate assembly to tractor
suspension
brackets
and retain with
single loop retainer springs as shown.
8. Position front plate assembly
between
front mower brackets. Raise deck and
plate assembly
to align holes and
insert flanged pins. Secure pins with
double loop retainer springs between
the plate and mower brackets.
NOTE: To assist in locating hole in
flanged pin, the hole in pin is inline with
notch on head of pin. If necessary,
move
mower side-to-side
to give space
between plate and mower brackets.
IMPORTANT:
Check belt for proper
routing in all mower pulley grooves.
9. Connect anti-sway
bar to chassis
bracket under left footrest and retain
with double loop retainer spring.
10. If equipped,
turn height adjustment
knob clockwise to remove slack from
mower suspension.
11. Raise deck to highest position.
12.Assemble
gauge wheels as shown
using long shoulder
bolts, 3/8 wash-
ers, and 3/8-16 center Iocknuts.
Tighten
securely.
13.Adjust
gauge wheels before operating
mower as shown in the Operation
section of this manual.
CHECK TIRE PRESSURE
The tires on your tractor were overinflated
at the factory for shipping purposes.
Correct tire pressure is important for best
cutting
performance.
• Reduce tire pressure to PSI shown in
"PRODUCT
SPECIFICATIONS"
section
of this manual.
CHECK MOWER LEVELNESS
For best cutting results, mower should be
properly leveled. See "TO LEVEL
MOWER HOUSING"
in the Service and
Adjustments section of this manual.
CHECK FOR PROPER POSITION OF
ALL BELTS
See the figures that are shown for
replacing motion, mower drive, and
mower blade drive belts in the Service
and Adjustments section of this manual.
Verify that the belts are routed correctly.
10
Hide quick links:
Advertisement
Table of Contents
