Gigabyte GA-MA790X-UD4 User Manual page 81

B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears (RAID hard drive will not be detected at this stage),
select Load Driver. (Figure 3).
Step 2:
Specify the location where the driver is saved (Figure 4). For users using a SA TA optical drive, be sure
to copy the driver files from the motherboard driver disk to a USB flash drive before installing Windows
Vista (go to the BootDrv folder and save the whole SB750V foler to the USB flash drive). Then use
Method B to load the driver.
Method A:
Insert the motherboard driver disk into your system and browse to the following directory:
\BootDrv\SB750V\LH
For Windows Vista 64-bit, browse to the LH64A folder.
Method B:
Insert the USB flash drive containing the driver files and browse to the LH (for Windows Vista 32-bit) or
LH64A (for Windows Vista 64-bit) folder.
Figure 3
Figure 4
- 81 - Appendix