Maintenance - Craftsman 315.171020 Owner's Manual

MAINTENANCE
, i
WARNING:
When servicing use only identical Craftsman replacement parts. Use of any other parts
may!
create a hazard or cause product damage.
GENERAL
Only the parts shown on parts list, page 11, are intended to
be repaired or replaced by the customer. All other' parts
represent an important part of the double insulation system
and should be serviced only by a qualified Sears service
technician.
Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to various types of commercial solvents and
may be damaged by their use. Use clean cloths to remove
dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts, They contain chemicals that can
damage, weaken, or' destroy plastic.
J
THE FOLLOWING RECOMMENDED ACCESSORIES ARE CURRENTLY
It has been found that electric tools are subject to accelerated
wear and possible premature failure when they are used on
fiberglass boats, sports cars, wallboard, spackling compounds,
or plaster. The chips and grindings from these materials are
highly abrasive to electric tool parts such as bearings, brushes,
commutators, etc, Consequently, it is not recommended that
this tool be used for extended work on any fiberglass material,
wallboard, spackling compounds, or plaster. During any use
on these materials, it is extremely important that the tool is
cleaned frequently by blowing with an air jeL
WARNING: I
Always wear safety goggles or safety glasses with side I
shields during power tool operation or when blowing dust. I
If operation is dusty, also wear a dust mask_ I
P
AVAILABLE AT SEARS RETAIL STORES.
9- 28900 6
For fast smooth cuts in woods, masonite, plastics, hard composition
board and all plunge cutting. Keyhole blade shape permits cutting in
hard to reach areas.
u ii ,,,n i,,,,n n,i ,,, i,,i ,,, iii ull I
For fast rough cuts in green or fibrous woods 1 in. or thicker, for notching
timber or joists, and for fast roughing-in_
ii
High speed steel blade for' cutting ferrous metals less than 1/8 in. thick
and for cutting tubing or pipe with a 1/8 in. thick wall section or less.
, lul i i
Designed for cutting flush to a wail or along a floor. For' fast smooth
cuts in woods, plastics, and hard composition board.
,, ,i , , i i, iii, i,i i ul
For fast, smooth, deep cuts through thick wood, plastic, composition
board, and hardboard.
For rough cuts in wood.
;_28gol g 3
9_28904 4 24
9_28984 6 7
IIII IIII
9_28902 12 6
ii
9.9.28903 6 14
WARNING: The use of attachments or accessories not listed above might be hazardous.
_, ,i, i d
EXTENSION CORDS
The use of any extension cord wilt cause some loss of power.
To keep the loss to a minimum and to prevent tool overneating,
use an extension cord that is heavy enough to carry the
current the tool will draw.
A wire gauge size (A.W.G _)of at least 16 is recommended for
an extension cord 75 feet or less in length_ A wire gauge
(A.W.G.) of at least 14 is recommended for an extension cord
75 - 100 feet in length. When working outdoors, use an
extension cord that is suitable for outdoor use° The cord's
jacket will be marked WA.
WARNING:
Check extension cords before each use. If damaged
replace immediately_ Never use tool with a damaged cord
since touching the damaged area could cause electrical
I
shock resulting in serious injury_
I i
Page 10