INSTALL BATTERY
(See Figs.
4 & 5)
CAUTION:
Do not short battery termi-
nals. Before installing battery, remove
metal
bracelets;
wristwatch
bands,
rings, etc.
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
Lift seat to raised position.
Open battery box door.
•
Be sure battery drain tube is attached to battery box.
°
Lower battery into battery box with battery terminals
toward front of tractor.
_-
First connect RED battery cable to positive (+) battery
terminal with hex bolt, flat washer, lock washer and hex
nut as shown.
Tighten securely.
•
Connect BLACK grounding cable to negative (-) bat-
tery terminal with remaining hex bolt, flat washer, lock
washer and hex nut, Tighten securely.
•
Close battery box door.
Open battery box door for:
•
inspection
for secure connections
(to tighten hard-
ware).
•
Inspection for corrosion.
•
Testing battery.
•
Jumping (if required).
°
Periodic charging.
BATTERY
BOXDOOR
POSITIVE
NEGATIVE
(RED) CABLE
(BLACK) CABLE
LOCK WASHER
POSITIVE (+) TERMINAL
NEGATIVE
(-) TERMINAL
FIG.4
BOX DOOR
VENT CAPS
FiG. 5
ASSEMBLE
GAUGE
WHEELS
TO
MOWER
DECK
(See Fig.6)
Assemble gauge wheels with tractor on aflat, level surface.
•
Adjust mower to desired cutting height (See 'q-O AD-
JUST MOWER CUTTING HEIGHT" in the Operation
section of this manual).
•
With mower in desired height of cut position, gauge
wheels shoutd be assembled So they are slightly off the
ground. Install gauge wheel in appropriate
hole with
shoulder bolt and 3/8-16 Iocknut and tighten securely.
•
Repeat for opposite side installing gauge wheel in
same adjustment hote.
GAUGE WHEEL
_._\
"_-_
MOUNTING
BRACKET
\
\
9
FIG. 6