Advertisement
REPLACING BATTERY
,i_WARNING: Do not short batteryterminals
by allowing a wrench or any other object to
contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
preventsparking from accidental grounding.
1. Lift hood to raised position.
2. Disconnect BLACK batterycable (A)then
RED battery cable and carefully remove
battery from tractor.
3. Instalf new battery with terminals in same
position as old battery.
4. First connect RED battery cable (B) to
positive (+) battery terminal with he× bolt
and keps nut asshown. Tighten securely.
Slide terminal cover (C) over terminal,
5. Connect BLACKgrounding cabteto nega-
tive (-) battery terminal with remaining
he× bolt and keps nut. Tighten securely
6,
Close hood.
Negative
(Black)
CabIe
Positive
(Red)
Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2, Remove bulb holderfrom the hole in the
backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back intothe hole in the
backside of the grill,
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO REPLACE FUSE
Replace with 30 amp automotive_type plug-
in fuse. The fuse holder is located behind
the dash.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to recon-
nect the headlight wire connector.
Headlight
Wire
Connector
TRANSMISSION REMOVAL!
REPLACEMENT
Should yourtransmission require removal for
service or replacement, it should be purged
after reinstallation and before operating the
tractor. See "PURGE TRANSMISSION" in
the Operation section of this manual.
ENGINE
TO ADJUST
THROTTLE
CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary,see engine manual.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be neces-
sary. Ifadjustment isnecessary, see engine
manual.
TO ADJUST CARBURETOR
Your carburetor hasbeen preset atthe factory
and adjustment should not be necessary.
However, minor adjustment may be required
to compensate for differences in fuel, tem-
perature, altitude or load. If the engine does
need adjustment, see engine manual.
27
Advertisement
