Troubleshooting - Craftsman 917.254220 Owner's Manual

Lt 10 hp electric start 4 speed - 36" mower lawn tractor
Table of Contents

Advertisement

TROUBLESHOOTING
WILL NOT START
PROBLEM
CAUSE/REMEDY
(SEE INDEX)
WILL NOT TURN OVER
Push Clutch/Brake
Pedal into Brake Position.
Move Attachment Clutch Lever to "Disengaged
Position
Fill Fuel Tank with Gasoline. Check Fuel Line and Carburetor
(clean if necessary) Replace Fuel Filter
Check fuse for fault and replace
Recharge or replace Battery
Check Wiring
Replace Spark Plug(s) and adjust gap
Charge
Battery
Replace
Ignition
Switch
Depress
Clutch/Brake
Pedal
Disengage
Attachment
Clutch
Lever
Replace
Interlock
Switch
Replace
Solenoid
Replace
Fuse
Check
All Wire Connections
Replace
Starter
ENGINE CLICKS
BUT WON'T
START
Charge
or Replace
Battery
HARD TO START
ENGINE
MISSES
OR LACKS
POWER
ENGINE
OVERHEATS
NO LIGHTS
WON'T
CHARGE
OPERA TOR PRESENCE SYSTEM
WILL NOT SHUT DOWN
_HEN
OPERATOR
LEA VES SEA 7",
Jote: This tractor is equipped with an operator presence sens-
ing system. Any attempt by the operator to leave the seat with
the enigne running and the attchment clutch engaged will shut
down the engine.
Place Throttle Control in "FAST"
position
and run starter several times to clear out gas
Remove and clean Fuel Tank and lines. Replace Fuel Filter
Remove Air Filter and clean
Replace Spark Plug(s) and adjust gap
Replace Battery
Check the wiring and Spark Plug(s)
Drain Fuel Tank and Carburetor, use fresh fuel and
replace Spark Plug(s)
Make necessary adjustments to Carburetor
Major Engine Overhaul
Shift
to a lower
gear or reduce
load
Remove
and clean Fuel Tank; replace
Fuel Filter
Remove
and clean Air Cleaner
Make
necessary
carburetor
adjustments
Clean Air Screen
Add or change
oil
Replace
Spark
Plug(s)
Check Spark
Plug/s)
and check for loose wires
Major
Engine
overhaul
Drain Fuel Tank and Carburetor
and refill
Clean Air Screen
Add
or change
off
Clean Engine
Cooling
Fins
Remove
and clean Muffler
or replace
Remove
and clean Air Filter
Use fresh fuel and adjust
Carburetor
Check
Fuse, Switch
and wire connections.
Replace
Headlight
Bulbs
Check
for Fuse fault and replace
Replace
Battery
Replace
Diode Assembly
Replace Alternator
Engage
attachment
clutch
Check
all wire connections
Check
seat switch
Check
operator
presence
relay.
Check PTO Switch.
25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents