Advertisement
TO POCKET
CUT
See Figure 20.
LOWER
BLADEGUARD
C-clamps, firmly clamp a straight edge to the
workpiece and guide the saw along the straight edge
to achieve a straight rip cut. Do not bind the blade in
the cut. If using the rip guide provided, see the
following instructions and Figure 22.
ALTERNATEMETHODFORRIP CUTTING
STRAIGHT
EDGE
POCKETCUT
LOWERBLADE
GUARD HANDLE
Fig. 20
,_
WARNING:
Always adjust bevel setting to zero
before making a pocket cut. Attempting a pocket
cut at any other setting can result in loss of control
of your saw possibly causing serious injury.
Adjust the bevel setting to zero, set blade to correct
blade depth setting, and swing the lower blade guard
up using the lower blade guard handle.
Always raise the lower blade guard with the
handle to avoid serious injury.
While holding lower blade guard by the handle, firmly
rest the front of the base flat against the workpiece
with the rear of the handle raised so the blade does
net touch the workpiece.
See Figure 20.
Squeeze the switch trigger to start your saw. Always
let the blade reach full speed then slowly lower
blade into the workpiece
until base is flat against
workpiece.
After you complete your cut release the trigger and
allow the blade to come to a complete stop. After the
blade has stopped, remove it from the workpiece.
Corners may then be cleared out with a hand saw or
sabre saw.
,_
WARNING:
Never tie the lower blade guard in a
raised position. Leaving the blade exposed could
lead to serious injury.
TO RIP CUT
OPTIONAL
RIP GUIDE
(EDGE
GUIDE)
See Figure 21.
Use a guide when making long or wide rip cuts with
your saw. An optional rip guide with a five inch scale
is available at your Sears Retail Store or you can
make an efficient rip guide by clamping a straight
edge to your workpiece. Secure the workpiece. Using
16
C-CLAMPS
TO ASSEMBLE
RIP GUIDE
•
Unplug your saw.
WORKPIECE
Fig. 21
_
WARNING:
Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
•
Place rip guide through holes in saw base as
shown in Figure 22.
(EDGEGUIDE)
RIP
NOB
PLACERIP
GUIDETHRU HOLES
Fig. 22
•
Adjust rip guide to the width needed.
•
Tighten rip guide knob securely.
When using a rip guide, position the face of the rip
guide firmly against the edge of workpiece. This
makes for a true cut without pinching the blade. The
guiding edge of workpiece must be straight for your
cut to be straight. Use caution to prevent the blade
from binding in the cut.
Advertisement
