Partssafety Key; To Turn On/Off; Removing/Installing Mulch Insert; Installing Grass Catcher - Black & Decker CMM1200 Instruction Manual

19" (483mm) cordless mulching rear bag mower
Hide thumbs Also See for CMM1200:
Table of Contents

Advertisement

Available languages

Available languages

OPERATION
PLEASE REFER TO DIAGRAMS
(A, B, C...) AND ITEM NUMBERS
(1, 2, 3...) AS NOTED THROUGHOUT
MANUAL.
FOR EXAMPLE,
A-1 REFERS
TO ITEM 1 IN FIGURE A.
KNOW YOUR MOWER
READ THIS INSTRUCTION
MANUAL AND SAFETY
RULES
BEFORE OPERATING
YOUR MOWER.
See diagram G to familiarize
yourself
with the location of various controls
and adjustments
referenced
below. Save this manual for future reference.
G-1 : Safety key
G-2: Switch lever
G-3: Handle adjustment
knobs
G-4: Handle storage knobs
G-5: Grass bag
G-6: Cut height adjustment
release
G-7: Cut height indicator
SAFETY
KEY
/_ DANGER : SHARPMOVINGBLADE,
In order to prevent accidental
start-up or unauthorized
use of your
Cordless Mower, a removable
Safety Key D-6 has been incorporated
into the design of your mower. The mower will be completely
disabled
when the Safety Key has been removed from the mower. With the
Safety Key removed, you will have access to the charger receptacle D-8.
AFTER REMOVING THE SAFETY
KEY, ONLY GRASP THE
PLASTIC
HANDLE
OF THE KEY, AS THE METAL MAY BECOME
WARM AFTER THE MOWER
HAS BEEN OPERATING.
NOTE: THE SAFETY
KEY HAS A STRAP ATTACHED
IN THE
CENTER TO ALLOW
FOR STORAGE
ON A NAIL, OUT OF THE
REACH OF CHILDREN.
DO NOT TETHER SAFETY KEY TO MOWER.
/_ DANGER:
ROTATING
BLADES CAN CAUSE SERIOUS
INJURY. TO PREVENT
SERIOUS
INJURY, REMOVE
SAFETY KEY
WHEN UNATTENDED,
OR WHEN CHARGING,
CLEANING,
SERVICING,
TRANSPORTING,
LIFTING, OR STORING MOWER.
TO TURN MOWER
ON
Insert Safety Key D-6 into the switch housing,
push in and rotate 1/4
turn clockwise
until safety key is fully seated inside housing.
The mower is now operational
and can be started by activating
the
switch lever.
z_ DANGER:
SHARP MOVING BLADE. NEVER ATTEMPT TO
OVERRIDE
THE OPERATION
OF THIS SWITCH AND SAFETY
KEY
SYSTEM AS SERIOUS
INJURY COULD RESULT.
ON-OFF
SWITCH
LEVER - FIGURE
H
Your mower is equipped with a special on-off switch system. To
operate the system, first push switch lever out (H-l),
then pull it to the
handlebar (H-2).To turn the mower off, just release the switch lever.
Once the switch lever has returned to the original position it will
activate the "Automatic
Braking Mechanism".
The motor is electrically
braked and the mower blade will stop rotating in 3 seconds or less.
MEETS CPSC SAFETY REQUIREMENTS
Black and Decker Mowers conform to the safety standards
of the
American
National Standards
Institute, and the U.S. Consumer
Product
Safety Commission. The Blade turns when the motor is running.
SAFETY
SHIELD
AND REAR DOOR
This safety shield I-1 is designed
to minimize
the throwing of stones or
other objects by the mower blade backward from under the mower
deck. The shield, along with the rear door I-2, minimizes
the possibility
of accidental
foot contact with the blade. DO NOT operate mower
without the safety shield and rear door in place.
z_ DANGER:
Sharp moving blade. For your own safety DO NOT
use this mower without either the grass catcher or mulch insert in
operating
position as serious injury could result.
Z_ DANGER:
Sharp moving blade. Do not operate the mower if the
rear door is not closed under spring tension as serious injury could
result. Take your mower to the nearest service center for repair.
REMOVING
MULCH
INSERT
To remove the mulch insert I-3 so that you can bag the grass or
discharge
with the optional discharge
chute, follow the steps listed
below:
1. Release switch lever to turn mower off, wait until the blade stops
and remove safety key D-6.
2. Raise the rear discharge
door I-2 and hold it up.
3. Locate your hand in the handle pocket I-4 as shown, and lift and
pull out the mulch insert I-3 completely.
4. The rear discharge
door is spring loaded. When you release it the
door will return to the closed position.
INSTALLING
MULCH
INSERT
1. Repeat steps 1 and 2 for removing
mulch insert.
2. Slide the mulch insert I-3 into the discharge
opening until it is firmly
in contact with the deck.
3. Release rear door and ensure it is properly closed.
INSTALLING
GRASS
CATCHER
1. Release switch lever to turn mower off, wait until the blade stops
and remove safety key D-6.
2. Reaching down between
the mower handles, raise the rear
discharge
door J-1 to a vertical position and hold the door up.
Ensure
that the mulch insert I-3 has been removed.
3. Pick up the grass catcher J-2 by the handle J-3 and place the
grass catcher between the mower handles as shown.
4. Position the grass catcher hanger hooks J-4 on the mower as
shown in Figure K. Release the rear discharge
door.
/_ DANGER:
Sharp moving blade. Never operate the mower
unless the hanger hooks on the grass catcher are seated properly on
the mower and the rear discharge
door rests firmly against the top of
the grass catcher as serious injury could result.
MOWING
TIPS
NOTE: ALWAYS INSPECT
AREA WHERE MOWER
IS TO BE USED
AND REMOVE ALL STONES, STICKS, WIRE, BONES AND OTHER
DEBRIS WHICH MIGHT BE THROWN
BY THE ROTATING
BLADE.
1. Mow across the face of slopes, never up-and-down.
Exercise
extreme caution when changing
direction on slopes. Do not mow
excessively
steep slopes. Always maintain
good footing.
2. Release switch lever to turn mower "OFF" when crossing
any
gravel area (stones can be thrown by the blade).
3.
Set mower at highest cutting height when mowing in rough ground
or in tall weeds. Removing too much grass at one time can cause
circuit breaker to trip, which stops mower. Refer to troubleshooting
guide.
4.
If a grass catcher is used during the fast growing
season, the grass
may tend to clog up at the discharge
opening. Release switch lever
to turn mower off and remove the safety key. Remove the catcher
and shake the grass down to the back end of the bag. Also clean
out any grass or debris which may be packed around the discharge
opening. Replace the grass catcher.
5.
If mower should start to vibrate abnormally,
release switch lever to
turn mower off and remove safety key. Check immediately
for
cause. Vibration
is a warning of trouble. Do not operate mower until
a service check has been made. Refer to troubleshooting
guide in
manual.
6. ALWAYS RELEASE
SWITCH
LEVER TO TURN MOWER
OFF
AND REMOVE SAFETY
KEY WHEN LEAVING
IT UNATTENDED
EVEN FOR A SHORT PERIOD OF TIME,
THE FOLLOWING
SUGGESTIONS
WILL HELP YOU TO OBTAIN
OPTIMUM
RUN TIME FROM YOUR CORDLESS
MOWER:

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents