X10 IN62A Setup Instructions

VCR Commander & FloodCam
(Install your FloodCam before getting started.)
Connect the power supply to the VCR
Commander and plug it into a wall outlet.
Press and hold PLAY until the LED stays on.
Have someone walk in front of your FloodCam
within 30 seconds of your pressing PLAY.
The LED on the VCR Commander will go
out.
Press and hold REC until the LED stays on.
Place your remote control 1 inch away from
the VCR Commander.
Press REC on the VCR Commander and
release it. The LED will blink quickly and then
stay on. Press the Record button on your
remote and keep pressing it until the LED on
the VCR Commander briefly goes out and
comes back on solid. This means that Record
has been learned.
Repeat these steps again for the STOP
function.
Get more help at: http://www.x10.com/support
Plug the IR emitter cable into the back of the
VCR Commander.
Press the emitter onto the VCR you are going
to control, after removing the plastic from the
adhesive backing.
GUIDE:
IN62A
Copyright 2001 X10 Wireless Technology, Inc. All rights reserved.