Jenn-Air EXPRESSIONS CVGX2423B Installation Instructions Manual page 11

Installation of LP Orifice Spuds
B. Invert Cap in Appliance Pressure Regulator
(See figures 7 and 8.) With the appliance installed, the
regulator is located on the underside of the burner box
on the right hand side at the inlet to the gas manifold.
Identify the make of appliance regulator on the unit and
follow the instructions in the appropriate illustration.
Figure 7: Conversion of Maxitrol
Appliance Pressure Regulator
Figure 6
With a quarter, engage slot and rotate cap 1/8 of a turn
counterclockwise. To remove cap, turn cap over and
reinstall.
Figure 8: Conversion of Harper-Wyman
Appliance Pressure Regulator
After conversion, steps A and B have been completed,
check the appearance of each burners' flame at the Hi and
Lo settings against figure 9. If the flames appear too large
or too small, review all steps to make sure they were
completed correctly.
Figure 9: Flame Appearance at Hi and Lo
6