Black & Decker LDX112 Instruction Manual page 8

when youturnoutthelights.
c.Move charger andbattery p ack toa location where t hesurrounding air
temperature is approximately 65°F - 75°F (18 °-24°C).
d.Ifcharging problems persist, take thetool, b attery p ack and charger toyour
local service c enter.
4.The battery p ack should berecharged when itfails toproduce sufficient power o njobs
which w ere easily d one previously. DONOT CONTINUE touseunder t hese conditions.
Follow thecharging procedure. Youmay also charge a partially used pack whenever
youdesire w ithnoadverse affect o nthebattery p ack.
5.Foreign m aterials ofaconductive nature such as,butnotlimited t o,steel w ool,
aluminum f oil,oranybuildup o fmetallic p articles should b ekept a way f rom charger
cavities. Always u nplug t hecharger from thepower supply w hen there isnobattery p ack
inthecavity. Unplug c harger before a ttempting toclean.
6.Donotfreeze orimmerse charger inwater o ranyother l iquid.
z_WARNING:
Shock hazard. Do not allow any liquid to get inside charger. Never
attempt to open the battery pack for any reason, ff the plastic housing of the battery pack
breaks or cracks, return to a service center for recycling.
SAFETY WARNINGS AND INSTRUCTIONS: DRILLS
1. Hold drill firmly with one hand on the grip and the other hand on the bottom of the
toot.
2. When attaching accessories in the drill chuck, hand tighten the keyless chuck firmly.
z_WARNING:
Drill may stall (if overloaded or improperly used) causing a twist. Always
expect the stall. Grip the drill firmly with both hands to control the twisting action and
prevent loss of control which could cause personal injury. If a stall does occur, release
the trigger immediately and determine the reason for the stall before re-starting.
INSTALLING AND REMOVING THE BATTERY PACK FROM THE TOOL
_WARNING:
Make certain the lock-off
button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery _"_
pack into toot, until an audible click is heard
(figure B).
TO REMOVE BATTERY PACK: Depress the
battery release button as shown in figure C
and pull battery pack out of tool.