Auto Return - Zenith SRV1341 Operating Manual & Warranty

TO CHECK THE START/END TIME
1) Press POWER button so that REC indicator goes off.
2) Press MENU button on the remote control.
3) Press MENU button to point to "TIMER
PROGRAMMING".
4) Select a program number you want to check. The
details of selected program will appear on the TV
screen.
5) Press MENU button. The TV screen returns to TV
mode.
HINTS:
• Make sure the channel you want to record is properly
set in advance.
• If you are recording using a Timer mode, you may
not operate the unit manually.
• Recording begins automatically at the Start time.
• It is not necessary to press RECORD button for timer
recording.
• The erase-prevention tab on the cassette must be in
place (or you must put tape over the hole).
• If the erasure protection tab is removed, the cassette
will be ejected when the POWER button is pressed
to off.
• If the tape runs out before the end time, the TV/VCR
will switch to the STOP mode immediately, and the
tape will be ejected.
With this feature, after timer recording is finished, the
beginning of the recorded program(s) can be searched
for automatically.
1 Select "USER'S SET UP"
[I_ -MENU-
Press MENU button to move to _,,_,,_R,_M,_
piCTURE CONTROL
SETTING CLOCK
"USER'S SET UP". _,,_,ELSETO,
USER'S SET UP
LANGUAGE [ENQLISPI]
CAPTION CAPTION 1 ]
TIME SEAI_CH
INOEX SEARCH
IJIII IIIIII I I I II I
.....
2
Set "AUTO RETURN" to [ON]
Press MENU button to point to [_ - u_R._ _ u, -
"AUTO RETURN". _,_,EMOOE lore
RENTAL [OPF"j
Press CH • or • button until ,EPEAT_Y ._.
[ON] appears. ,'._O._'.,R.
.......ll -: : : : = " : _ ! ! ill i i ill!it i i
3
Auto Return will begin
When all the timer recordings are completed, the
TV/VCR will rewind to the beginning of the recorded
program(s).
NOTES:
• If you press POWER button while tape is rewinding,
the Auto Return will stop.
• Counter Memory function cannot be used in this
mode.
- 29 - EN
6F06