Advertisement
GET TO KNOW
YOUR REMOTE
(MBR3457)
SPECIAl,
FEATURES
AUX+I, AUX+2, AUX+3
Your remote ('an control up to seven products. If you've
programmed
the remote for four products using the TV, VCR,
,CABLE, and AUX keys, you can program it for up to three more
by using AUX+ 1, +2, +3.
To Program AUX+I,
AUX+2, and AUX+3
1. Locate the three-digit code for your product in the code table.
9. Press and hold PRG until the indicator lights.
3. Press AUX and "1"
simultaneously
to select AUX+I.
4. Enter the three-digit code, then press ENTER. The indicator light
should flash, then turn off to indicate the code was accepted. If the
light stays on, repeat steps 3 and 4 or try a different code.
5. Repeat steps 2 - 4 for AUX+2 and AUX+3.
6. Write your codes on the label inside the battery
compartment
for future reference.
Hold down ALIX and press 1, 2, or 3 to access AUX +1, +2, or +3
mode.
CABLE
BOX
VOLUME
Your remote can control cable box volume and muting, if
available
on your cable box.
121
1"o Program the Cable Box Volume
Program your cable box code into the CABLE or the AUX key.
Repeat the: programming steps, using the same CABLE or AUX
key as above, but enter special code 3-9-9, followed by ENTER.
AMPLIFIER VOLUME OVERRIDE
Your remote can override your "IV, VCR, or video disc player's
volume functions with your amplifier's volume and muting.
To Program the Amplifier Volume Override
1. Program your amplifier code into the CABLE or AUX key.
2. Select the key on your remote (TV, VCR, etc.'_ where you
want the amplifier
volume control function to appear. For
example, pJressTV if you want to operate your amplifier's vol-
ume and mute while the reraole is in TV mode.
3. Enter special code 4-9-9, fall awed by ENTER.
The amplifier volume and mute features are now available in the TV
mode.
Notes:
1:1 To restore normal volume and muting control to your re-
mote, reprogram the remote for the product into each key
(TV, VCR, etc.) to be restoxed.
CD and tape players will automatically select amplifier
volume and mute, if an amplifier code is p:ogrammed into
the remote.
Note: To restore "IV volume/mute control to the CABLE or
AUX key, reprogram your cable code into that key.
3:,1:-o
4 -- 7
4"7
/
Advertisement
