Table of Contents
Advertisement
REMOTE CONTROL
(CONTINUED)
BATTERY
INSTALLATION
1. Slide the battery compartment cover in the direction
of the arrow.
2. Install two "AA" (penlight size) batteries, paying
attention to the polarity diagram in the battery
compartment.
3. Replace the compartment cover.
BATTERY
PRECAUTIONS
The precautions below should be followed when using
batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the
batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
To avoid a potential short circuit, insert the "-" end first.
3. Do not mix different types of batteries together (e.g.
Alkaline and Carbon-zinc) or old batteries with fresh
ones.
4. If the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be
recharged; they can overheat and rupture. (Follow
battery manufacturer's
directions.)
6. When you change the batteries, try to complete the task
within three minutes. If you take longer than three
minutes, the remote control codes for your Cable Box
may have to be reset (see page 8).
EFFECTIVE
DISTANCE
OF THE REMOTE
CONTROL
TRANSMITTER
NOTES:
• When there is an obstacle between the TV and the transmitter, the transmitter may not operate.
• When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on the
Remote sensor of the TV, the remote operation may be unstable.
6
Advertisement
Table of Contents
