JVC RX-DV3SL Instructions Manual page 23

• Speaker informationm"SUBWFR (subwoofer),"
"FRNT SP (front speaker)," "CNTR SP (center
speaker)," and "REAR SP (speaker)"
To obtain the best possible effect from the Surround modes (see
pages 25 to 28), register the following information after all
connections are completed.
• Forsubwoofer:
Dle_rAL _ TO
[] [] ....._K. ..............
• • • • • • • • • • ,, J J ,m, _L_E
'... J J J...' J. J J... J.." .. ..,,.J J J
ir-
....: :...: 1...: :.:.: ] 1'-. :: i i :...: J_
Select one of tile tbllowing settings:
YES : Select this when a subwoofer is connected.
NO : Select this when no subwoofer is used.
Notes:
• "NO"is the initial setting.
• If you have selected "NO" for the subwoofer, you can only select
"LARGE" for the front speakers.
• Forfront speakers,center speaker,andrear speakers:
[] [] m 2,, _ ...................... VOLUME
' ' '"' ' ' ' ' " ' ' " " !r_.,
.'-- .-p J '.J J ". p.. .. J PP J '_
: : '. J J J ....' J " J.... J '. '..." I.J
Dlorr_ _
[] [] ...._ .....
• • • • • • • ._' j..... .m' J..J J VOLUME
•1 ..".l .l ..1.-" -_..1.... _ IZ' 1111 ll'-
•...':: : :'. --. i il .... i*_
[] [] ,,,, g& ....
L.'i.. i i L" "-' i:::'[] ':::'M i ......
,r
i",i,- _ i". --:i [] ,,,,:i ii .... I_
Select one of |he tbllowing settings tbr each speaker:
LRG (large) : Select this when the speaker size is rela/ively
large.
SML (small) : Select this when the speaker size is rela/ively
small.
NO : Select this when you have not connemed a
speaker. (Not selectable for the front speakers)
• Speaker distance--"FRNT D (front distance),"
"CNTR D (center distance)," and "REAR D
(distance)"
[] [] ,,,,,2_ ....
I I I L I I _', II '_ i"_1 i', ,j,, /'OL_UEI_
l I == I I I L=' " .l. '...' l '.' I ,,,.I
m0rr_ _1_
[] [] ,,, .%_,-
• • • • • • • .'•'. .. ,l .m. .'. l VOLUME
I IN I I I_ = I I ,, i I ,'1 ,h 'T'
IP
1....11 1 i". :" 11 .i. 1:..1 1 1.' i_
[] []--&._ ....
• • • • • • • Jill 11 li ,HI e 111 i VOLUME
k"_ ',,i IT' ii :: i i,"i 'i' "i" !1_
i_1
The distance fl-om your lis/ening point to the speakers is another
important element to obtain the best possible surround sound of
the Surround ]nodes.
You need to set the distance from your listening point to the
speakers. By referring to the speaker distance setting, this unit
automa/ically sets the delay time of the sound through each
speaker so that sounds through all the speakers can reach you at
the same time.
Set the distance from the listening point within tl_e range of
1 ft (0.3 m) to 30 ft (9.0 m), in 1 ft (0.3m) interval.
Left _onl Centerspeaker Rightfront
speaker speaker
Subwoofer
ilfl
"'R {3.3 m)
', 101/
', (3.0m) ',
'< (2.7,m) ,
8ft , i
(2.4 m) / I i
/ / l
/
/
Left rear "'--- _- Right rear
speaker speaker ,'
-. J
Notes:
• "LRG (large)"is the initial setting for the front speakers, "SML
(small)" for the center and rear speakers.
• Keep the following comment in mind as reference when
adjusting the settings.
- ff the size of the cone speaker unit built in your speaker is
greater than 4 _/4inches (12 cm), select "LRG (large)," and if
it is smaller than 4 _/_inches (12 cm), select "SML (small)."
• Ifyou have selected "SML (small)" forthe front speakers, you
cannot select "LRG (large)" for the center and rear speakers,
Ex. : In this case,
set "FRNT D" to "1 lft,"
set "CNTR D" to "10ft" and
set "REAR D" to "gft."
Notes:
• "fOft'is the initialsetting. If you have already changed the
setting, another setting will be shown,
• If you have selected "NO"for the center and rear speakers
setting, you cannot set the speaker distance for the center and
rear speakers.
20