Using The Real Time Capture - Sanyo PLC-XU355A - 3500 Owner's Manual

Using the Real Time Capture

This is a function to project the screen image of the computer by the projector in real time. The
captured image projected by the projector can be selected from the computer, web browser and the
projector respectively.
Registering the computers
Up to 30 computers can be registered.
1
Access to the control page of the projector by using the web
browser. From the Network menu, click Capture tab to display
the setting page.
2
Switch to Connection Setting page by clicking the page
number tab [3]. Enter the IP address of the computer to the PC
number, and then click Set button. Click Set button to register
the IP address for each page.
✐ The registered computer enables to start capturing if only the Network Capture 5 is activated.
✐ The transfer speed of the captured image using the Real Time Capture function is depending on the network
environment and data volume of the image. It cannot be supported for movie pictures.
✐ The projector can not reproduce the sound during the real time capturing.
✐ "Spinning wait cursor
✐ If you start capturing with the Select capturing object on the parameter set up window checked, the Select
capturing object window below(right side) appears. Select the desired window title from the window list and click
OK button.
If no window is opened, no window title is displayed on the window list as shown on the left figure. Even the
new window is opened,
the display of the Select
capturing object window
would not change. If you
would like to capture the
new window opened, click
Update button to show
the window title on the
window list, select it and
click OK button.
" cannot be captured.
Using the Real Time Capture