Table of Contents
Advertisement
Troubleshooting
Use the following information to solve common problems.
The LED doesn't blink when a button is pressed.
Replace the batteries. See "Inserting Batteries" on page 9.
The LED blinks when a component mode is pressed, but the
component does not respond.
Make sure that you are less than 15 feet (4.57 meters) from the
infrared remote sensors on the component.
Make sure that nothing is blocking the infrared remote sensors
on the remote control or the component.
Make sure that you have selected the correct component mode.
Make sure that the remote is programmed for that component.
See "Programming the Universal Remote Control" on page 12.
The remote control will not accept the component program code.
Make sure that you followed all the steps in the programming
procedure. See "Programming the Universal Remote Control"
on page 12.
Make sure that you tried all the program codes listed for the
component manufacturer. See "Component Program Codes"
on page 13.
Search for the component code. See "Searching for
Component Codes" on page 24.
The remote control can't operate micro chip display projection TV.
Make sure the TV button has been pressed. See page 2.
Re-install batteries into remote control.
Advertisement
Table of Contents
