Epson Pro 7600 Unpacking And Setup Manual page 13

Assembling the Stand
c
Caution:
Assembly requires two people. Be careful to
match the right and left legs (R and L is engraved
on the inner side of the base parts) and base parts.
1. Insert the right leg into the right base by
sliding the leg slot onto the base projection as
shown. Fasten the leg to the base with 2 base
bolts (J).
J
2. Assemble the left leg and left base in the same
way as step 1.
3. Insert the bottom horizontal strut into the
right and left bases as shown. Use the hex
wrench (I) to fasten the strut with strut bolts
(K), then insert plugs (M) over the bolts.
Note:
After assembling the bases and bottom horizontal
strut, make sure that they are fastened tightly.
4. Insert the top horizontal strut into the right
and left legs. Use a screw driver to fasten the
strut with + head screws with washers (L).
5. This completes assembly of the Stand. Make
sure each part of the Stand is tightened
securely.
Mounting the printer on the Stand
c
1. Position the printer and the Stand as shown.
Then lock the casters of the Stand.
Note:
Place the casters sideways and lock them so they
will not move.
M
K
L
Caution:
Two or more people are required to mount the
printer. Hold the printer at the indicated
locations as shown. If the ink cartridges are
installed, do not tip the printer at an angle.
Otherwise, ink may leak from the cartridges.
L
11