Download Print this page
Jenn-Air Expressions CVEX4100 Installation Instructions Manual
Jenn-Air Expressions CVEX4100 Installation Instructions Manual

Jenn-Air Expressions CVEX4100 Installation Instructions Manual

Expressions convertible cooktop series
Hide thumbs Also See for Expressions CVEX4100:

Advertisement

r
INSTALLATION
INSTRUCTIONS
ExpressionsConvertible ,_=JENN..AIR
CooktopSenes
[ wE6 00_,_,REET_H
,_
Models CVEX4100, CVEX4270 & CVEX4370
IMPORTANT
• Installation s houldbe performed bya Jenn-Air a uthorized servicer o rotherqualified installer.
• ReadSafetyPrecautions i ntheUse&Caremanual b eforeusing thisappliance.
INSTALLER
• Saveinstallation i nstructions forlocalelectrical inspector's u se.
• Leaveinstallation instructions withthe appliance,
CONSUMER
• Retaininstallation i nstructions withthe appliance.
_ay
berotated f orhorizontal
or vertical d irection b y loosening
nuts around b lower inlet. Accessible
inside v entilation chamber.
I
g
20_"-+
1/16"
+_1/16"or + .16 cm
52.23 cm + .16cm
A Cul_ut
8"
Cutout
20.30 cm
2Y8"
5.40 cm
_,°
IMPORTAN"
CUTOUT
DIMENSIONS
No_s
ARE CRITICAL
A
B
C
D
E
CUTOUT
CUTOUT
DUCT
DUCT
MIN. CABINET
WIDTH
DEPTH
OPENING
OPENING
WIDTH
inches
cm
inches
cm
inches
cm
inches
cm
inches
cm
Single Bay
18 11116 47.48
20 9/16 52.23
6 916
16.03
14 7/16 36.67
21
53.34
Double Bay
307/16
77.34
20 9/16 52.23
17 3/4 45.08
14 7/16 36.67
33
83.82
Triple Bay
41 31/32 160.60
209/16
52.23
173/4
45.08
14 7/16 36.67
45
114.30
8101P414-60
(lo-ol-oo)

Advertisement

loading
Need help?

Need help?

Do you have a question about the Expressions CVEX4100 and is the answer not in the manual?

Questions and answers

Summary of Contents for Jenn-Air Expressions CVEX4100

  • Page 1 CooktopSenes [ wE6 00_,_,REET_H Models CVEX4100, CVEX4270 & CVEX4370 IMPORTANT • Installation s houldbe performed bya Jenn-Air a uthorized servicer o rotherqualified installer. • ReadSafetyPrecautions i ntheUse&Caremanual b eforeusing thisappliance. INSTALLER • Saveinstallation i nstructions forlocalelectrical inspector's u se. • Leaveinstallation instructions withthe appliance, CONSUMER •...
  • Page 2 SINGLE See side clearance )1 I<---- note below. TT__-'_ 314, I In Clearance/ Required,_ "t- 171/2" [ 1"-1-3 Grease 44.460m/I II I I I , Container SEE NOTE I LI BELOW J" 12 1i2 "-_1 BELOW 31.76 cm DOUBLE note below, See side clearance 1(--i 1 4J-J#4 c...
  • Page 3 Installing Cabinetry Over Your Electrical Wiring Information Jenn-Air Grill The neutralof this unit is groundedto the frame through the green grounding wire. If used on new branch-circuit A = 30" (76.2 cm) minimum clearance between the top of installations (1996 NEC), mobile homes, recreational...
  • Page 4 Preparing Unit For Assembly In Countertop 1. Unpack Unit. 2. Providecutoutfor countertopand duct openingsas required per page 1. 3. Place unit in the cutout, and slide unit all the way to the left hand side of cutout. (Figure 1). 4. HOLDING DOWN UNIT TO COUNTERTOP: Use the hold down straps, provided in the hardware package, to _."",,_.,.,,,,_-,_:! ."-",...
  • Page 5 2nO Eowards Street, SE Ceve!_nd. Tennessee 37311 Tei: 4 23-472-3333 Fax: -t23-478-67 I0. FLOOR VENT CUTOUT (JOISTS AS SHOWN) - Check the direction of the floor joists (see illustration). If the joists" .direction is as shown, locate the cutout on the "T" as illustrated. The cutout must miss the floorjoists! - Cutout may be moved from side to side on line to clear floor _ist.
  • Page 6 2&OEawards$tree!, SE C;a'leiand,Tennessee 37311 TeJ: J -23-,:77_-_333 Fax:_23--;78-_7!0 13. INSTALL BLOWER (PRIOR TO INSTALLING RANGE) - Refer to your vent plan. It may be desirable to attach part of the ducting to the blower before it is installed. - Position the blower (see illustration) and attach it to the floor with at least two (2) screws. - Apply duct tape around blower exhaust/duct joint.
  • Page 7 2_0EdwardsStreet,SE Cieve!and, T en_esse_ 37311 Tei: _13-472-3_3 Fax:a23-47S-87tO 16. CONNECT ELECTRICAL (FOUR CONDUCTOR WIRE) - CAUTION: Make sure power to cable is OFF. - Remove the range electrical service cover located on the back, lower left-band corner. Remove the ground strap screw and bend the strap up as shown. - install a 3/4"...
  • Page 8: Power Cord

    Z_O E_watds S treet. S E C',eveie nd.Tennessee 37311 Te!:422-_72-3333 7-ax: _23-_78-67:0 19. ANTI-TIP BRACKET INSTALLATION - With the unit installed in the final location, establish left side and back of the unit. - Locate left bracket 5/8" (1.58 cm) in from the left of the unit. - Locate the right bracket 27 7/8"...
  • Page 9: Lower Door

    2.40 E dwards Stree[. SE C;eveiana, Tennessee 373] l Tei: 4 22-477_-,2333 Fax: _t22-._7_-6770 22. INSTALL FLEX DUCT - Attach the flex duct to the blower and range (See illustration). Using a screwdriver, securely tighten duct clamp at each connection. 23.

This manual is also suitable for:

Expressions cvex4270Expressions cvex4370