Advertisement
Before assembling, please review all instructions.
1. Carefully open box to avoid damaging the lamp when using a sharp
knife.
2. Remove lamp (fully assembled) and set on table.
3. Using a Philips head screwdriver (included), carefully unscrew
the three screws holding the Optix
Remove filter and save for later.
4. Carefully insert the GU-24 Natural Spectrum
into lamp by firmly holding bulb base and pushing down and
rotating slightly in a clockwise direction to seat properly. Note:
Make sure bulb is fully inserted into the socket. The bottom of the
bulb base should touch the plastic housing of the lamp.
5. Place Optix
tighten Philips head screw. DO NOT OVERTIGHTEN. Insert the
two remaining screws and tighten.
6. Plug lamp into an appropriate outlet and turn on the switch.
7. Adjust height for optimum illumination.
8. Do not use with an extension cord or on a circuit with a dimmer
switch.
9. Save the packaging in case you need to send the lamp to Verilux
for servicing.
Assembly Instructions
filter on lip of of inner shade cup, align holes and
®
Glare Control Filter in place.
®
®
4
light bulb (included)
®
Advertisement
