Table of Contents
Advertisement
OCE-0026G(MX-6000)_REV04.QXD
Connecting the Battery Pack
Unlock the rear cover by pressing down on the two locking tabs
and sliding the battery cover forward.
Remove the cover. For shipment from the factory, the battery is left
out of the MX-6000. Place the battery into the battery compart-
ment, making sure you align the contacts on the battery to the con-
tacts on the MX-6000. The battery will snap into place when
aligned properly.
Replace the cover and snap it into place.
Using the Charging Base
Plug the 6V DC adapter into a power outlet and into the back of
the charging base.
Gently place the MX-6000
into the cradle of the charging
base. It automatically aligns
itself to the contacts on the
charging base.
The Status light should imme-
diately light. Red indicates
that it is charging. Blue shows
that it is fully charged. There is
no harm in leaving the MX-
6000 on its charging base
whenever it is not in use.
Two Way via WiFi
To use the MX-6000 with any two way companion product, the
MX-6000 must be configured by your installer to be part of a LAN
(local area network) via a WiFi b/g access point or router. This is
not user configurable. If you have any questions, consult with your
custom installer.
2/22/11
10:17 AM
MX-6000 T
W
T
WO
AY
Red indicates charging, Blue that the remote is fully
charged.
Page 5
Page 5
S
OUCH
CREEN
Hide quick links:
Advertisement
Table of Contents
