Epson LX-810 User Manual page 215

Problem
Using the roll paper
holder, paper does
not feed properly.
W h e n t h e
L O A D / E J E C T
b u t t o n
is pressed, the
platen does not
rotate and paper
does not feed.
W h e n t h e
L O A D / E J E C T
b u t t o n
is pressed, the
platen rotates but
paper does not feed.
The paper feed is
crooked or the paper
jams.
Solution
You may be trying to feed paper while the
printer is on line (ON LINE light is on).
Press the ON LINE button once to set the
printer off line; then feed the paper. After
feeding the paper, press the ON LINE
button again to set the printer on line.
Refer to 3-3.
The paper release lever may be pulled
forward to the continuous paper position.
Push the paper release lever back to the
single sheet position. Refer to 5-31.
The position of the roll paper may be
wrong. Position the paper roll so that the
paper feeds off of the bottom of the roll.
Refer to 5-33.
The roll paper holder may not be installed
correctly. Check that the holes in the base
fit onto the two corresponding pegs at the
bottom of the printer. Refer to 5-30.
The shaft with the paper roll may not be
properly mounted on the roll paper holder.
Make sure the shaft fits securely onto the
roll paper holder. Refer to 5-33.
Troubleshooting
Options
7-29