HP EVA P6000 Reference Manual page 26

Figure 19 Complete cabling for a P6500 EVA 2C6D to 0C4D expansion
a. Remove the cable between P2 (I/O-A) on the middle disk enclosure and P1 (I/O-A) on
the bottom disk enclosure.
NOTE:
except for disk enclosures that are connected to the controllers. The break described in
Step 2
b. Using one of the 6m cables from the expansion kit, connect P2 (I/O-A) on the middle
disk enclosure in the main rack to P1 (I/O-A) on the top disk enclosure (first domain) in
the expansion rack (1,
c. Using one of the 6m cables from the expansion kit, connect P1 (I/O-A) on the bottom
disk enclosure in the main rack to P2 (I/O-A) on the bottom disk enclosure (first domain)
in the expansion rack (2,
d. Remove the cable between P2 (I/O-B) on the middle disk enclosure and P1 (I/O-B) on
the bottom disk enclosure.
e. Using one of the 6m cables from the expansion kit, connect P2 (I/O-B) on the middle disk
enclosure in the main rack to P1 (I/O-B) on the top disk enclosure (first domain) in the
expansion rack (3,
f. Using one of the 6m cables from the expansion kit, connect P1 (I/O-B) on the bottom disk
enclosure in the main rack to P2 (I/O-B) on the bottom disk enclosure (first domain) in
the expansion rack (4,
3. In the group of disk enclosures below the controller enclosure:
a. Remove the cable between P2 (I/O-A) on the top disk enclosure and P1 (I/O-A) on the
middle disk enclosure.
26 Connecting the main rack to the expansion rack
You can break the connection between any disk enclosures in the main rack
and shown in the completed cabling
Figure 19).
Figure
Figure 19).
Figure
(Figure 19 (page
19).
19).
26)) is just one example.