Replacing The System Motherboard; Motherboard Part Numbers; Before Replacing The Motherboard- A Note About Licenses; Ilo2 Licenses - HP D2D Service And Maintenance Manual

3 Replacing the system motherboard

For all products, G1 and G2, refer to the appropriate Maintenance and Server Guide for detailed
instructions on replacing the motherboard. This chapter describes the following tasks that are
specific to HP D2D Backup Systems:
Set the J27 jumper on HP D2D4106/41 12 G2 and HP D2D2502/2504 G2 products.
Update BIOS IDs on all products.
Reinstate iLO2 licences on all G2 products
Reinstate the RAID 6 license for the integral RAID controller on HP D2D4324/4312 products
IMPORTANT:
cards into the same slot from which they were removed. See also the rear view drawings in Chapter
1.

Motherboard part numbers

HP D2D4324/4312 G2 Backup Systems: The motherboard for the HP D2D4324/4312
Backup System is the standard DL370 G6 motherboard. Please refer to DL370 G6 Maintenance
and Service Guide for details of how to replace it.
IMPORTANT:
ON - to ensure that the motherboard is seen as a DL370 and not an ML370.
HP D2D4106/41 12 G2 and HP D2D2502/2504 G2 Backup Systems: The motherboard for
both the HP D2D4106/41 12 Backup System and the HP D2D2502/2504 Backup System is
part number: 583724-001.
All G1 HP D2D Backup Systems: The motherboard for all G1 products is the standard
motherboard.
Before replacing the motherboard— a note about licenses

iLO2 licenses

All G2 products are shipped with paper copies of the iLO2 licenses. If you no longer have these
licenses and the board is still working for the iLO2 GUI connection via its management Ethernet
port, make a note of the license before you remove the motherboard. (If it is not working, contact
HP Support.)
1. Log on to the iLO2 GUI.
2. Select the Administration Tab.
3. Select Licensing and make a note of the License Key.
NOTE: G1 products do not support iLO2.

SAAP licence (HP D2D4324 and D2D4312)

The Smart Array Advanced Pack (SAAP) is required to enable RAID 6 support. You must reinstate
the SAAP license, if you replace the motherboard on an HP D2D4324 or D2D4312 product,
because it has an integral P410i card. If you do not, the system will experience one of the following
symptoms :
When replacing the motherboard (or individual cards) be sure to always replace
Please ensure that the system maintenance switch SW1, S3 setting is set to
Motherboard part numbers 19