Fibre Channel Card Leds; Capacity Upgrade Kit Leds - HP D2D Installation And Configuration Manual

2. Disk beacon LED
Beacon mode
The HP StoreOnce Backup System supports a Beacon LED sequence, which helps a user identify
which unit is being configured, if several are connected to the network. There is also a Beacon
LED on the individual disks so that you can identify a specific disk within the HP D2D.
Use the Network page of the Web Management Interface to turn Beacon Mode on and off for the
HP StoreOnce Backup System. This turns the Beacon LED on the front and the rear of the HP D2D
solid blue. If you do not switch off Beacon Mode, it will continue for 5 minutes. You can also switch
Beacon mode on and off by pressing the LED on the front panel.

Fibre Channel card LEDs

If you have a Fibre Channel version of the HP StoreOnce Backup System, there are three LEDs
adjacent to each FC port.
Table 2 FC card LEDs
Yellow LED
Off
On
Flashing
Alternately flashing
Off
Off
Off
Off
On
Flashing

Capacity upgrade kit LEDs

There are three LEDs on the front of the Capacity Upgrade Kit.
48 Understanding LEDs
Green LED Amber LED
Off Off
On On
Flashing Flashing
Alternately flashing Alternately flashing
Off On
Off Flashing
On Off
Flashing Off
Off Off
Off Off
Off: The disk is not a part of RAID
Steady blue: identifies a specific disk within the unit
Activity
Power Off (OK)
Power on before or after software initialization.
Awaiting HBA software initialization.
Power on after software initialization. Link not
initialized.
software fault (OK)
Connected at: 2 (HP D2D4300 Series only) or
1 (all other FC systems) Gb/s
Activity at 2 (HP D2D4300 Series only) or 1
(all other FC systems) Gb/s (OK)
Connected at 4 (HP D2D4300 Series only) or
2 (all other FC systems) Gb/s
Activity at 4 (HP D2D4300 Series only) or 2
(all other FC systems) Gb/s (OK)
Connected at 8 (HP D2D4300 Series only) or
4 (all other FC systems) Gb/s
Activity at 8 (HP D2D4300 Series only) or 4
(all other FC systems) Gb/s