Table of Contents
Advertisement
MCS-100
SECTION 3: SYSTEM OPERATION
The MCS-100 is very sophisticated, but the operation is simple. Your two button RF transmitter is easy to use for arm,
disarm, personal protection, and programming the system for many custom functions.
3.1 Remote System Arm (On)
Press and release RF transmitter button #1.
One siren chirp sound and a light flash verify the operation.
If you hear four chirp sounds, the MCS-100 has detected a faulty sensor.
3.2 Remote System Disarm (Off)
Press and release RF transmitter button #1.
Two siren chirps and two light flashes verity this operation.
Note:
If you hear three chirp sounds, the system has been triggered and the alarm was activated while you were
away from the vehicle. Please refer to following chart. This diagnostic report will turn off when ignition
switch is turned on.
Shock Sensor
Optional Input Trigger (Mercury Switch, Microwave & etc)
3.3 Personal Protection Alarm (EMERGENCY PANIC)
Press and hold down RF transmitter button #1 for approximately three seconds.
Personal Panic alarm is activated and siren sounds and lights flash for one (1) minute.
Press and release any RF transmitter button to cancel the panic alarm.
3.4 Motorcyle Finder Mode
Press and hold down RF transmitter button #3 (#1+#2) for approximately three seconds.
Lights flash for one (1) minute.
Press and release any RF transmitter button to cancel the Motorcycle finder mode.
SECTION 4: PROGRAMMABLE FEATURES
Programming Function
Code Program Method 1
Code Program Method 2
(4.1)
Permanent Siren Chirp Disable
Permanent Siren Chirp Enable (4.2)
One Time Soft Chirp (4.3)
Emergency Disarm (4.4)
Passive Mode
Active Mode (4.5)
Version A
Diagnostic Report
Programming Method
Power On. Within 3 seconds, press button #1 of new
transmitter. Press button #1 of 2
press button #1 of 3
Turn Ignition On/Off 5 times. Press button #1 of new
transmitter. Press button #1 of 2
press button #1 of 3
Turn Ignition on. Press button #2 for 5 seconds
Press #2 before other function buttons.
Turn Ignition On/Off 4 times. Alarm will disarm.
Turn Ignition on. Press button #3 (#3 = #1 + #2) for 5
seconds.
Audible - Chirp
3 chirps
3 chirps
nd
transmitter and then
rd
transmitter.
nd
transmitter and then
rd
transmitter.
4
Visual - LED
Double Flashes
Rapid Flashes
Chirp
1
1
None
2
2
1
2
Light
1
1
1
2
2
1
2
Advertisement
Table of Contents
