Using Epson Calibration
To run the CALIBRAT.EXE utility program, follow these steps:
1. Insert the diskette containing the calibration utility into your
computer's diskette drive.
2. In DOS, access the drive where you have loaded the diskette.
3. Change the current directory to UTILITY (that is, type
A:\UTILITY if
CALIBRAT,
4
Type
5. Follow the instructions on the screen to calibrate your printer.
Note:
also copy the program from the diskette to your hard disk Then
You can
change the current directory (or set the path to the directory), type
CALIBRAT, and press Enter.
1-20
Setting Up the Printer
the diskette is in drive A).
Enter.
and press