Seating - Golden Technologies LiteRider GL110 Owner's Manual

LiteRider™ Owner's Manual Rev.A_122810
V. OPERATION

SEATING

Armrest Width Adjustment
To adjust the armrest width:
1. Loosen the adjustment knobs at the rear of the seat.
See #1 on figure 6.
2. Slide the armrests in or out to the desired width.
3. Tighten the adjustment knobs.
Be sure adjustments knobs are securely
1
tightened against the inserted armrest tube. Do not
exceed the maximum armrest width of 24 in.
Flip-up Armrests
Figure 6. Armrest Width Adjustment
Pull up on the end of either armrest to flip it up
for easy transfer on and off your Golden LiteRider™.
See #1 on figure 7.
1
Armrest Angle
To increase the armrest angle, turn the armrest
angle screw counterclockwise. See #2 on figure 7.
To decrease the armrest angle, turn the armrest
angle screw clockwise.
Seat Rotation Lever
The seat can be rotated through 360° and locked at
2
any 45° position.
1. Push down on the seat rotation lever and rotate
the seat to the desired position. See #1 on figure 8.
2. Release the handle to lock the seat at any
Figure 7. Flip-up/Angle Adjustment
45° position.
Seat Height Adjustment
To adjust the seat height:
1. Lift the seat up and off of the seat pedestal.
2. Remove the nut and bolt that holds the seat
post in the seat pedestal. See #2 on figure 8.
3. Position the seat post at the desired height
while aligning the holes in the seat post and 1
the seat pedestal.
2
4. Reinstall the nut and bolt.
5. Replace the seat back onto the seat pedestal.
Figure 8. Seat Height/Rotation Adjustment
18