Sony Handgcam CCD-FX425 Operation Manual page 19

By using the Remote Commander, you can be in the picture with your friends and family,
or conveniently control the playback of your tape from a distance.
1
Insert two size AA (R6) batteries with
the + and - ends properly
positioned.
2
Se, the [].E.OTE CO..A.OE. " ,,
I,,k_l, ll_ /
switch on the battery mounting surface ....... _.,L_7:_,_ .[
of the camcorder. _ -"_- J
If the battery is attached, remove it.
Reattach the battery after setting the
REMOTE COMMANDER ON/OFF switch.
3
4
Set the POWER switch on the camcorder as follows:
-- When camerarecording, 1) pressthe small green button on the POWER switch
and slide it to CAMERA, 2) set the STANDBY switch up.
-- When playing back, slide the POWER switch to PLAYER.
, _-TT-----Remote sensor
Aim the Commander at the remote L..__
sensor on the camcorder and 2m (6 6 "ft___,-_-- ___
press the appropriate button on
the Commander.
v \ _->,.. _Y30 o
(Approximate maximum distance and angles for remote control)
Note on the Remote Commander
• Keep the remote sensor away from strong light sources such as direct sunlight or illumination.
Remote control with the Commander may not function properly under such circumstances.
, The command mode of the Commander is VTR2. Avoid using the Sony VCRs with the same
command mode at the same time.
Getting familiar with some buttons
HOLD switch
When you slide the switch in the direction of the
arrow, all the buttonswill become inoperableto
prevent any misoperation shouldyou
accidentallypress the buttons.
I=.- SLOW and DATA SCREEN buttons
You can use the functions of these buttons only
with the Commander.
SLOW
SCREEN
Battery life In normal operation, batteries last up tO six months. If the camcorder does not
operate properly, the batteries might be exhausted. Replace both batteries with new ones.
To avoid damage from possible battery leakage
Remove the batteries when you will not use the Commander for a long time.
When you connect the receiver of a remote control kit
When you connect the receiver of a remote control kit (not supplied) to the REMOTE
control connector, be sure to set the [] REMOTE COMMANDER switch on the battery
mounting surface of the camcorder to OFF.
Basic Camera Operation
19