Satellite Receiver And Cable/Antenna - Sony WEGA KLV-S20G10 Operating Instructions Manual

Connecffng_e TV
Satellite Receiver
and Cable/Antenna
"_ t°If you connect the
Digital Satellite
Receiver with
component video
cables, see page 23.
This scenario shows a SAT Box connected through the video inputs and the
Cable/Antenna connected through the VHF/UHF input. Satellite signals are
selected by the SAT Box through the video inputs while TV signal is
selected by the TV tuner.
To connect a satellite receiver
1
Connect the satellite antenna cable to the satellite receiver's satellite
input jack.
2 Use A/V and S VIDEO cables to connect the satellite receiver's AUDIO
and S VIDEO output jacks to the TV's AUDIO and S VIDEO input
jacks (VIDEO I IN).
3 Connect the supplied 75-ohm coaxial cable from the antenna to the
TV's VHF/UHF input jack.
4- Run the Initial Setup program, as described in "Setting Up the Channel
List" on page 31.
f/_ If your satellite receiver is not equipped with S VIDEO, usea
VIDEO cable (yellow) instead of the S VIDEO cable.
_Lat_i li_leSRG_cO iver I _Satellite antenna
s...Lu..., i UJ cable
:L...oo..00.o°.oooL..o.o .v,oEo
2
Rear of TV
S VIDEO cable
:i!!i:: :<!!iii) _WDE0
/ ;)
():
A/V cable
S VIDEO _i
R
r©
AUDIO L
L©
NONO)
WDEO@
0_1_,_ AUDIO-R (red) l_
AUDIO-L (white)
) VIDEO (yellow)
75-ohm coaxial
cable
"-I
(Continued)
21