Preparing Batteries; Power - Sony Cyber-shot U DSC-U30 Operating Instructions Manual

Preparing batteries
Use the following batteries in this camera
Acceptable batteries
HRI 145:HR03 (size AAA) Nickel-Metal
Hydride batteries (2)
NH-AAA-DA (2) (supplied)
NH-AAA-2DA twin-pack (not supplied)
Batteries that cannot be used
Manganese batteries, lithium batteries.
Ni-Cd batteries, alkaline batteries
\\then the above batteries are used,
operation is not guaranteed due to possible
voltage drops or other characteristics of the
batteries
In addition, the battel 3" remaining indicator
is not displayed correctly
Charging the batteries
--I_ Insert Nickel-Metal Hydride
batteries into the battery
charger (supplied) with the
correct polarity +1-.
For details on the supplied battel_- charger
see page 76
• You cannot use any batte_3_ other than a
Nickel-Metal Hydride battery Also, operations
are not guaranteed when using a Nickel-Metal
Hydride battery f_om a lnanufacrurer other than
Sony
• Be sure to charge the Nickel-Metal Hydride
batteries supplied with your camera before
using theln for the first time,
• Conuect tile bakery charger to an easily
accessible wall outlet (wall socket) close by
CHARGE lamp
To the wall outlet
I_ (wa!l socket)
Power cord
_=_ : (mains lead)
=1_ Connect the battery charger to
a wall outlet (wall socket) using
the power cord (mains lead).
The CHARGE lamp lights up when
charging begins, and goes off _hen
charging is completed
• E_'e_ if the CHARGE lamp is not ht, the batter?'
charger is not disconnected froln the AC power
source (mains) as long as it is connected to the
wall outlet (wall socket) If some trouble occurs
while/_sing the bat_e_>' cha_ge_', immediately
shut offthe power by disconnecting the plug
fiom the wall outlet (wall socket)
• When charging is finished, disconnect the
power cord (mains lead) from Ne wall outlet
(wall socket), and remove the Nickel-Metal
Hydride batteries fiOln the battery charger
10