Advertisement
Available languages
Available languages
Check the antenna orcable c onnection
tothemain unit.
Check the batteries oftheremote control.
Check ifthere isanobstacle between theinfrared sensor window a nd the
remote control.
Test thesignal output. IfOK, then possible infrared sensor trouble.
(Refer to"lR Signal Check" onpage 3 6.)
Myremote control does n ot w ork. What
Aim theremote control directly attheinfrared sensor window onthefront
should I do?
oftheunit.
Reduce thedistance totheunit.
Re-insert
thebatteries with their p olarities (+/-signs) as indicated.
When t here isaninfrared-equipped
device s uch a s PC near this unit, i t
may interrupt theremote control signal ofthis unit.
Move t heinfrared-equipped
device away f rom this unit, c hange theangle
oftheinfrared sensor orturn offthe infrared communication
function.
HOW c ome t heInitial setup a ppears every
, connect
the RF coaxial cable tothe
unit directly
and run the initial setup
time I turn on this unit?
• Make sure to complete
the channel
scan before turning
off the unit.
• Make sure auto channel
scan has been completed.
(Refer to "Auto Channel Scan" on page 18.)
• Auto channel
scan must be completed
when you set up the unit for the
first time or move it to a location
where previously
unavailable
channels
are broadcast.
• The selected channel
may not be broadcasting.
Why I cannot watch some of TV programs?
• When auto channel
scan is interrupted
and not completed,
some channels will not be received.
Make sure to complete.
(Refer to "Auto Channel Scan" on page 18.)
• The selected channel
cannot be viewed
by the V-chip setting.
(Refer to "V-chip" on page 28.)
• The unit requires some kind of antenna
input. An indoor
antenna
(rabbit
ears), an external antenna,
or an RF coaxial cable from your wall or cable
/satellite
box needs to be plugged
into the unit.
How come there isno image from the
'Check
if the fight
inPut mode is Selected by pressing
[INPUT SELECT]
or
_nnected
external devices?
using [CH A/V
]. (Refer to 'Switching
Each Input Mode!on
page 15.)
• Check the antenna
or cable connection
to the unit.
Whenever
I entered
channel
number,
• Many digital
channels
have alternate
channel
numbers.The
unit changes
the numbers
automatically
to the ones signifying
the broadcasting
it changes automatically,
stations. These are the numbers
used for analog broadcasts.
, Captions
that are de!ayed a few seconds behind the actua! dialogue
are
Why are captions
not displayed
entirely?
common
for live broadcasts.
Most captioning
production
companies
can
Or, captions
are delayed
behind the
display a dialogue
to maximum
of 220 words per minute. If a dialogue
dialogue,
exceeds that rate, selective
editing
is used to insure that the caption s
remain up4o
date with the current TV screen dialogue.
How can I set the clock ?
• There is no clock function
on this unit.
EN
Advertisement
