Advertisement
Available languages
Available languages
[] Channel
Selection
Select channels by using[CHA/V]
or [the Numberbuttons].
Use [CH •
/ V] or [the Number
buttons]
to select the
memorized
channels.
0
0
0
0O@
or
000
00
Using [the Num her buttons]
- When selecting
analog channel
12
[]Volume
Adjustment
Thissection describes h owto adjustthevolume. T hemutefunction, w hich
turnsthesoundoff andon, isalsodescribed.
Use [VOL _/T]
to adjust the audio volume.
• The volume
bar will be displayed
atthe
bottom
of
the TV screen when adjusting
the volume.
• The volume
bar will automatically
disappear
in a few
seconds.
Press [MUTE D_] to turn offand
on the sound.
MUTE
- When selecting
digital
channel
12-1
• Be sure to press
[-1 before
entering
the minor
channel
number.
• Press [CI-I RETURN]
to return to the previously
viewed
channel.
• Only [the Number
buttons]
can be used to select
the non-memorized
channels.
About
digital
TV broadcasting:
With its high definition
broadcast,
digital
broadcasting
far surpasses analog broadcasting
in both its picture
and sound quality.
Not all digital TV broadcasts
are high
definition
(HD). To confirm
whether
your watching
TV
program
is in HD, refer to the program
guide, contact
your cable/satellite
provider
or local TV stations.
What is the minor
channel?
By using high compression
technology,
digital
broadcasting
offers a service that enables
multiple
signals to send simultaneously.
Therefore,
you can
select more than one program
per major channel since
digital
broadcasting
technology
distinguishes
between
multiple
channels
broadcast
by a single network.
NTSC
_
ATSC
(analog mode)
(digital mode)
18:oo
........ 1 8:30
ii!!i[ii
19:oo
iii:
_
iiiililililili
19:30
20:00
<_:_: can be changed
by using [CH A IV].
Note:
• "No Signal'willappearon
the TVscreen after the minor
channel broadcast is over.
• "Audio onlyprogram" message will appear on the TV
screen, when you receiveonly sound signal
• "Mute"
is displayed
on the TV screen for a few
seconds.
Press [MUTE D:_]again or use [VOL _/_]
to recover
the original
volume.
[] Sleep Timer
Thesleeptimer canbeset toautomatically turnoff theunit after an
incremental p eriodoftime.
Press [SLEEP] to set the sleep timer.
SLEEP
• Sleep timer display appears
on the TV screen.
2
Press [SLEEP] repeatedly
to change the amount
of time
until shut off.
SLEEP
• You can setyour
unit to turn offafter
a set period
of
time (from 30 to 120 minutes).
• Each press of [SLEEP] will increase the time by 30
minutes.
• After setup, the sleep timer display can be called up
for checking
by pressing [SLEEP].
To cancel the sleep timer
Press[SLEEP]repeatedly until "Sleep Off" is displayed
on the -IV screen.
Note:
• The sleep timer display will automatically
disappear in a
few seconds.
• Whenyoudisconnecttheunitfrom
theACoutletorwhen
a power failure occurs, the sleep timer setting will be
canceled.
EN
Advertisement
