Installation Instructions; Reversing The Door Swing - GE GBC12 Owner's Manual And Installation Instructions

Installation
Instructions
If you have questions, call 1.800.561.3344
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
local inspector's use.
IMPORTANT –
•
and ordinances.
Note to Installer –
• Be sure to leave these
instructions with the Consumer.
Note to Consumer –
•
future reference.
• Skill level – Installation of this appliance requires basic
mechanical skills.
• Completion time – Refrigerator Installation
15 minutes

Reversing the Door Swing

1 hour
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature will
go below 55°F (13°C) because it will not run often enough
to maintain proper temperatures.
• Install it on a floor strong enough to support it
fully loaded.
• Do not install it closer than 5" (13 cm) next to a range.
Save these instructions for
Observe all governing codes
Keep these instructions for
Refrigerator
geappliances.ca
or
visit our Website at:
CLEARANCES
For optimal performance of your refrigerator, the following
clearances are recommended:
• Sides 3 / " (0.9 cm)
8
• Top 1" (2.5 cm)
• Back 2" (5 cm)
LEVELING LEGS
Adjustable legs at the front corners of the refrigerator
should be set so the refrigerator is firmly positioned on
the floor, and the front is raised just enough that the door
closes easily when opened about halfway.
To adjust the leveling legs, turn the legs clockwise to
raise the refrigerator, counterclockwise to lower it.
To raise the refrigerator
INSTALLING THE HANDLES
Remove the plug buttons from the left side of the doors.
Install the handles using the screws provided, and snap
screw covers in place.
8
Model GBC12
.