TRENDnet TW100-BRV204 User Manual page 62

TW100-BRV204 User Guide
For each rule, the following data is shown:
Data
•
•
•
•
To add a new rule, click the "Add" button, and complete the resulting
Add
screen. See the following section for more details.
To Edit or modify an existing rule, select it and click the "Edit" button.
Edit
There are 2 ways to change the order of rules
Move
•
•
To delete an existing rule, select it and click the "Delete" button.
Delete
Clicking the "View Log" button will open a new window and display
View Log
the Firewall log.
Clicking the "System Rules" button will open a new window and
System Rules
display the default firewall rules currently applied by the system. These
rules cannot be edited, but any rules you create will take precedence
over the default rules.
Name - The name you assigned to the rule.
Source - The traffic covered by this rule, defined by the source IP
address. If the IP address is followed by ... this indicates there is
range of IP addresses, rather than a single address.
Destination - The traffic covered by this rule, defined by destina-
tion IP address. If the IP address is followed by ... this indicates
there is range of IP addresses, rather than a single address.
Action - Action will be "Forward" or "Block"
Use the up and down indicators on the right to move the selected
rule. You must confirm your changes by clicking "OK". If you
change your mind before clicking "OK", click "Cancel" to reverse
your changes.
Click "Move" to directly specify a new location for the selected
rule.
58