F Terminal Delay; Hz Per User-Defined Unit; Input Feedback Selection - Toshiba W7 Installation And Operation Manual

F Terminal Delay

F Terminal Delay
Program Terminal Settings
Delays F
This parameter delays the response of the ASD to any change in the F terminal
input by the programmed value.
The delay may be increased to provide additional electrical noise immunity or
to prevent the ASD from responding to contact bounce or chatter.

Hz Per User-defined Unit

Program Utilities Display Attributes
This parameter allows the user to input a quantity to be displayed on the EOI
that is proportional to the output frequency of the drive.
This feature is useful when the output of a process is moved along at a rate that
is proportional to the output frequency of the drive.

Input Feedback Selection

Program Feedback Settings
This parameter Enables/Disables PID feedback control. This parameter is
enabled by selecting a source for motor-control feedback.
Settings:
PID (Control) Disabled
VI/II
RR
RX
RX2 (option)
76
Terminal Delays Input Terminal
Hz Per User Defined Unit
Input Feedback Selection
Input Feedback Selection
Parameter Type — Numerical
Factory Default — 8.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.0
Units — Hz/UDU
Parameter Type — Selection List
Factory Default — PID Disabled
Changeable During Run — Yes
W7 ASD Installation and Operation Manual