Texas Instruments Extensa 51x Maintenance Manual page 24

3.
4.
5.
6. Insert the edge of the DIMM Board into the lower connector (refer to
7.
8.
This completes the expansion memory module installation procedure.
2-2 Installation
Release the Keyboard by pulling the keyboard release tabs forward
(tabs are located underneath the Ctrl and right arrow keys).
Disengage the Keyboard using a straight blade screwdriver and gently
lifting up along the front edge of the keyboard.
Using the back edge of the keyboard as a hinge, lift the front edge of
the keyboard up and lay it against the display.
Figure 2-1). Use a rocking motion to fully insert the module. Push
downward on each side of the DIMM module until it snaps in place.
Repeat the procedure in Step 6 (upper connector) to install the second
DIMM module.
Replace the keyboard assembly and any other components removed in
Step 1.
Figure 2-1
Slide Keyboard Release
Tabs toward front of
notebook.
Using a small
flat blade screwdriver,
gently pry keyboard up
along the front edge.
Tilt the keyboard back
against the display
Insert the SIMM modules
into the two Main Board
memory connectors
Installing Additional Memory
1
2