Superior EDGE TRIM KITS Installation Instructions

FOR USE WITH SUPERIOR'S WOOD BURNING APPLIANCES

SHIPPING AND PACKING LIST

Edge Trim Kit must include:
1 - RH Side Trim
1 - LH Side Trim
1 - Top Frame Trim
1 - Lower Mounting Frame Trim*
2 - Upper Mounting Frame Trim*
*Note: Upper and lower mounting frame trim included with
Models 42 only.
The Edge Trim Kits covered in this document are:
Catalog #
91L57
91L58
91L61
91L62

FIREPLACE EDGE TRIM KIT INSTALLATION INSTRUCTIONS

Step 1. Remove fireplace grille assemblies by lifting up and out of holes
on frame. Then pull from bottom out towards you. ( Figures 1 and 2 ).
Note: Lift grille near outer support rods to fully clear holes.
Step 2. There is a right hand and a left hand trim. Install side trims
carefully. Place trim on side frame and press firmly to fit around
frame ( Figure 1 ).
Step 3. Install the top frame trim with two screws as shown in
Figure 2 .
Note: The ends should overlap the side trim pieces a little.
Step 4. 42 Models only. Install one of the two upper mounting
frame trim pieces by aligning the three holes of the trim to the three
holes of the fireplace. Fasten with three screws.
INSTALLATION INSTRUCTIONS FOR EDGE TRIM KITS
Model #
ETK36-B
ETK36-P
ETK42-B
ETK42-P
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
WOOD BURNING APPLIANCE
KITS AND ACCESSORIES
750,058M
11/2000

Step 5. 42 Models only. Install the lower mounting frame trim.

Align the two holes of the trim to the two holes of the fireplace.
Step 6. 42 Models only. Align the two end holes of the second
upper mounting frame with the holes on the lower fireplace frame
and secure with two screws.
Step 7. Adjust all trim pieces and ensure that all screws have been
tightened. Reinstall louvers.
Step 8. Remove protective covering from trim pieces and wipe with a
damp cloth.

Step 9. Reinstall louvers.

Figure 1
EDGE TRIM KITS