Superior LK36-B Installation Instructions

INSTALLATION INSTRUCTIONS FOR GRILLE TRIM KITS
FOR USE WITH SUPERIOR'S WOOD BURNING APPLIANCES

SHIPPING AND PACKING LIST

Grille Trim Kit must include:
6 Grille Trim (Full Length)
The Grille Trim Kits covered in this document are:
Catalog #
91L55
91L56
91L59
91L60

GRILLE TRIM KIT INSTALLATION INSTRUCTIONS

Step 1. Remove fireplace grille assemblies by lifting up and out of holes
on frame. Then pull from bottom out towards you. ( Figures 1 and 2 ).
Note: Lift grille near outer support rods to fully clear holes.
Step 2. Insert grille trim onto grille and bend tabs over and around
until fully secured ( See Figure 3 ). Bend tabs utilizing the flat end of a
screw driver or pliers.
Step 3. Remove protective covering from decorative grille trim
pieces and wipe with damp cloth.
Step 4. Replace grills by aligning top ends of rods to upper set of holes
on corresponding frames. Swing grilles towards frame in the same
manner as they were removed and allow rod bottoms to fall into bottom
holes until fully secured. Make sure all rods are completely inside holes.
Decorative
Louver Trim
Figure 3
FireCraft Technologies reserves the right to make changes at any time, without notice,
in design, materials, specifications, prices and also to discontinue colors, styles and
products. Consult your local distributor for fireplace code information.
Model #
LK36-B
LK36-P
LK42-B
LK42-P
Grille Assembly
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
WOOD BURNING APPLIANCE
750,054M
05/2001
Figure 1
Bend Tab Over
With The Flat End
Of A Screw Driver
Or Pliers.
Louver Trim
Shown In Place
Figure 2
KITS AND ACCESSORIES
GRILLE TRIM KITS
Printed in U.S.A. © 2000 by FCT
P/N 750,054M REV. B 05/2001