If Something Goes Wrong; Before You Call For Service - GE Spacemaker JVM1730 Owner's Manual

If Something Goes Wrong

Before You Call For Service

Problem Possible Cause
Oven will not
A fuse in your home
start
may be blown or the
circuit breaker tripped.
Power surge.
Plug not fully inserted
into wall outlet.
Door not securely closed. • Open the door and close securely.
Floor of the oven is The cooktop light is
warm, even when located below the oven
the oven has not floor. When the light
been used is on, the heat it
produces may make the
oven floor get warm.
"LOC" appears
The control has been
on display
locked.
Vent fan will not
The vent fan
turn off
automatically turns on
to cool internal parts
while the microwave
is on.
"BAD PROBE" The probe has not been
appears on display completely inserted into
the oven wall outlet.
The probe is defective.
"PLEASE INSERT
Probe has been
PROBE " appears
forgotten or not
on display
inserted properly.
"SENSOR ERROR" When using a Sensor
appears on display
feature, the door was
opened before steam
could be detected.
Steam was not detected
in maximum amount
of time.
36
What to Do
• Replace fuse or reset circuit breaker.
• Unplug the microwave oven, then plug
it back in.
• Make sure the 3-prong plug on the
oven is fully inserted into wall outlet.
• This is normal.
• Press and hold CLEAR/OFF for
about 3 seconds to unlock the control.
• The vent fan cannot be turned off
while the microwave is operating.
This is normal. Wait for the microwave
to turn off and the fan will either go
off automatically or you will need to
turn it off by pressing the Vent Fan
pad after the microwave is off.
• Insert the probe properly into the
oven wall outlet.
• Replace the probe.
• Insert the probe properly into the
oven wall outlet.
• Do not open door until steam is
sensed and time is shown counting
down on display.
• Use Time Cook to heat for more time.