Table of Contents
Advertisement
operate your camcorder during this time.
The following states will be indicated if data is still being written onto the recording media after recording
has finished. During this time, do not apply shock or vibration to the camcorder, or remove the battery or
AC Adaptor.
Access lamp (p. 22) is lit or flashing
The media icon in the upper right of the LCD screen is flashing
Tips
See page 103 on the recordable time of movies.
You can record photos during movie recording by pressing PHOTO fully (Dual Rec, p. 31).
When a face is detected, a white frame appears and the image quality around the face is optimized
automatically ([FACE DETECTION], p. 82).
You can specify the priority face by touching it (p. 30).
You can capture photos from recorded movies (p. 47).
You can check the recordable time, estimated remaining capacity, etc., by touching
[Show others] [MEDIA INFO] (under
The LCD screen of your camcorder can display recording images across the entire screen (full pixel
display). However, this may cause slight trimming of the top, bottom, right and left edges of images when
played back on a TV which is not compatible with full pixel display. In this case, set [GUIDEFRAME] to
[ON] (p. 81), and record images using the outer frame displayed on the screen as a guide.
[
STEADYSHOT] is set to [ACTIVE] in the default setting.
Data code during recording
The recording date, time and condition are recorded automatically on the recording media.
They are not displayed during recording. However, you can check them as [DATA CODE]
during playback. To display them, touch
[PLAYBACK] category) [DATA CODE] a desired setting
SET] (under
.
Shooting photos
In the default setting, photos are recorded on the internal memory.
Tips
To change the recording media, see page 20.
Press MODE to turn on the
The LCD screen display switches for photo recording mode, and the screen aspect ratio
becomes 4:3.
[MANAGE MEDIA] category).
(MENU) [Show others] [PLAYBACK
(Photo) lamp.
(MENU)
US
Advertisement
Table of Contents
